The Box - Set Up Instructions
SET UP INSTRUCTIONS:
1. Lay the package for The Box on its back, with the cover facing directly up before opening. Then open the package lid for The Box
2. Remove the tray from the package and place on tabletop, near an electrical outlet (outlet must be capable of providing 60W at 12V 5A)
3. Remove both hoses from the package and place them to the side on a clean surface
4. Remove the Box from the package and place into the Tray
5. Remove the power cord from the package & plug the power cord into the electrical outlet and the Box
6. Press the Box’s power button located on the top right corner of the product, so it can begin getting ice cold. It will take a few minutes to get to ideal temperature and can take longer if you’re setting up to use the Box in a hot weather environment
7. If desired, fill the Box by pouring no more than 1.5 fl oz into the downstem
8. Identify the glass N Adapter and put it into the downstem of the Box, this keeps your heating element away from the Box and assists with cleaning
9. Decide if using the Box in stand-alone mode with your heating element or if you want to use the Box with your waterpipe
a. If using the Box in stand-alone mode: insert the handle into the long hose and then insert the adapter on the hose into the output hole on the top left front part of the Box. Then remove the handle mount adapter and place in the side cutout on the left side of the Box. The handle can be placed in the handle mount for a more vertical storing means, or it can lay in the tray horizontally
b. If using the Box with your waterpipe: insert the adapter with the spring side from the small hose into the output hole on the top left front part of the Box. Then take the adapter and plug it into your female 14mm taper joint. If plugging into a 10mm waterpipe then add the 14mm to 10mm adapter to the hose adapter before plugging into your waterpipe
10. Choose your heating element and add to the female taper of the N Adapter
a. If using a 14mm nail, vaporizer, bowl or another device plug directly into the N-Adapter
b. If using a 10mm nail, vaporizer, bowl or other device then insert the 14mm to 10mm adapter into the N Adapter before adding in the heating element
c. If using a electronic device you may need to use the small hose or other ‘whip’ system to go from the mouthpiece/output of the device then into the N Adapter inserted into the Box’s downstem
11. Load your consumable into heating element, activate, and begin pulling with your breath to fill the Box with your desired smoke or vapor, then pull harder with your breath to inhale all the contents inside the Box AKA ‘clear’
a. Between uses, if there is left over smoke or vapor trapped inside of the Box that you don’t want to inhale, it can be removed from the system by removing the downstem and hose from the Box then blowing through the output hole on the left side of the Box. This can be also done using a air blower (The TSB on Invest in Headies can make this easier with its air blower that can be turned on low to blow the trapped smoke or vapor out of the system)